Focusable Lighthead   Different design than other HID's with the main ballast in the canister with the ignitor in a small housing at the head   Switch is recessed into the lid for additional protection   Powered by a 20 Amp Li-Po Battery Providing 330 Mins.(5.5 hours) of Burntime   35 Watt HID with 3000 Lumen Output @ 6000 Kelvin   New Dry Lid is completely sealed providing protection from water intrusion due to a cut cord or switch boot   Battery Canister is completely sealed preventing water intrusion due to improperly latched lid or forgotten o-ring   Dry Weight 7 lbs.(3.2kg) 3 lbs(1.36 kg) Negitive   Recharge Time from Complete Discharge 12 hours   Universal Input Charger. US Input Cord Provided, UK and European Input Cord Available   Canister and Head Machined from Solid Rod Delrin   11.5"(291mm) Length, 3.5"(88mm) Diameter   DUAL OUTPUT AVAILABLE IN 20 and 26 AMP MODELS ONLY

  LD-15 Primary Light 1500 Lumen High @ 16W, 1100 Lumen Medium @ 10W, 800 Lumen Low @ 5W 6.0 degree beam angle Up to 10 hours burn-time (see Matrix) Side and Top gland options Over heat protection for the LED’s, can be used on low out of the water Over charge, discharge, short circuit, and drain protection on the battery pack All UW Light Dude battery packs are TSA compliant for air travel   What’s in the box? Complete Light System (Head, Cable, Canister) Handle & Clip (inc. optional Hard Goodman Bracket) 2 x 316 Stainless Boltsnaps (for handle and head) Canister rigging for 2″ webbing or sidemount Charger base for Sealed External Charging System 110-240v AC Charger   Technical Details: Battery Size(Watt Hours) 54 (Mini), 107 (Short), 160 (Tall) Output(Lumens) 1500 Beam Angle(Degrees) 6 Burn Time(Hrs) 3.3 (Mini), 6.6 (Short), 10 (Tall) Cable Gland(Routing) Side Gland, Top Gland Due to TSA policy, UW Light dude can lights cannot be expedited by using standard air freight.  If you like to expedite it by air, extra charges will apply. 

The After two years of development, we are pleased to announce the release of the 26W LED Primary light.light heads for the 26W LED are machined from aluminum and then black hardcoated to allow for optimal heat sinking. The Reflector was designed to provide a 6° center hot spot for effective signaling. You can get it with 3 different Canister options: --Powered by a 10Ah Li-ion battery pack (providing 230 minutes of burn time) --Powered by a 15Ah Li-ion battery pack (providing 345 minutes of burn time) --Powered by a 20Ah Li-ion battery pack (providing 460 minutes of burn time) 1700 Lumen Output @ 6000 Kelvin 9 inch (22.7cm) Length, 3 inch (7.62) Diameter Dry Weight is 4.5lbs(2kg) 1lbs(.45kg) Negative in-water Recharge time from complete discharge:  6 hours 9.0 ELC – 111wh TSA compliant for air travel   DUAL OUTPUT AVAILABLE IN 20 and 26 AMP MODELS ONLY        

The LD-35 has an 8.20 degree beam that produces 3500Lumen of light on setting one at 30 watts. Setting three can be used safely out of the water. The light will turn to setting three if it is used out of the water and it reaches maximum temperature limit. Once it falls below the temperature limit it can be returned to the higher light levels. While in the water the heat sinking will ensure the light remains well below its temperature limit.

The promise of LED technology that can fully replace HID lighting just took a step forward with Halcyon’s newest Eos primary light. The new Eos capably blends numerous desirable features with a focused light output exceeding the 10-watt HID. The Eos also reduces battery consumption with an efficient array of dual-intensity LEDs—a quick flip of the switch more than doubles the battery’s run time! A machined aluminum head shields a nearly indestructible LED light array with an expected lifecycle of 20,000 hours. A set of innovative Halcyon features round out the Eos by adding a custom tie point for the Goodman handle and a specially machined rear bolt-snap attachment point. The Halcyon Eos represents the dawn in a new age of underwater lighting and is a welcome addition to our line of primary lighting. Eos LED Key Features Advanced LED array provides powerful 600 Lumen output in a small, attractive form. Lux rating at one meter is 10700; at three meters, 1450; and at five meters, 530. High-quality, aluminum light head with a Type 3, Class 2 Mil-Spec hard coat is durable and corrosion resistant. Aluminum light head optimizes heat dissipation while protecting LED electronics. High-quality LEDs are rated for approximately 20,000 hours and protected by a nearly indestructible light head. The dual-intensity LED allows an option to double battery run time. The built-in thermal protection circuit auto-switches to low intensity to protect LED array from overheating when out of the water. The Eos Goodman handle features an innovative bolt snap attachment point. The light head body provides a rear bolt snap attachment option. The charger has a switchable universal input, 110-240v. The Eos LED is pressure tested and depth rated to 300ft/90m. There is a lifetime warranty on the canister. The Eos comes standard with our indestructible Explorer canister featuring our proprietary “dry lid” design.   12-watt LEDSpecifications 4.5 Amp HourBattery Pack Full Power:5-hour run time Half Power:10-hour run time 2.6” OD/11.63” L (6.6cm OD/29.5cm L)Weight: 4lb. (1.8kg)Buoyancy: -1.75lb. (-0.8kg) 9 Amp HourBattery Pack Full Power:10-hour run time Half Power:20-hour run time 2.95” OD/11.63” L (7.5cm OD/29.5cm L)Weight: 5.76lb. (2.6kg)Buoyancy: -2.8lb. (-1.3kg) 13.5 Amp HourBattery Pack Full Power:14-hour run time Half Power:28-hour run time 3.68” OD/11.63” L (9.3cm OD/29.5cm L)Weight: 7.75lb. (3.5kg)Buoyancy: -3.2lb. (-1.5kg)

This light is under the 300 watt hours that TSA requires.  You can take this as a carry on.  EX:The 20amp version puts out only 197 watt hours. Focusable Lighthead   Different design than other HID's with the main ballast in the canister with the ignitor in a small housing at the head   Powered by a 10 Amp Li-Po Battery Providing 300 Mins.(5 hours) of Burntime   21 Watt HID with 1500 Lumen Output @ 6500 Kelvin   New Dry Lid is completely sealed providing protection from water intrusion due to a cut cord or switch boot   Dry Weight 5.8 lbs.(2.6kg) 2.5 lbs(1.1 kg) Negitive   Battery Canister is completely sealed preventing water intrusion due to improperly latched lid or forgotten o-ring   Recharge Time from Complete Discharge 5 hours   Universal Input Charger. US Input Cord Provided, UK and European Input Cord Available   Canister and Head Machined from Solid Rod Delrin   10.75"(27.2 cm) Length, 3"(7.5 cm) Diameter

Built for the Sidemount diver, this butt mountable light has everything you need!  The Sidemount 12 Watt LED is powered by a 5.2 amp Li-ion rechargeable battery pack. Burntime is 5 hours and outputs 750 lumens at 5600 kelvin and has a 6 degree focused beam. Emitter life is 50,000 hours. Comes with an elastic handmount for hands free diving. The light is activated by rotating, eliminating the need for a switch in the canister. The canister is 2"(5cm)in diameter and 7.5"(19cm) in length. Weights in at 2.5 lbs.(1.1kg). The charger accepts 90 to 240 volt input and recharge time is 4 hours from a complete discharge. Charging is done by removing the lighthead from the tail piece. The battery pack for the Rebel 9 watt LED can also be used to power the lighthead for a 2.5 hour burntime and is available separately. LED's generate heat when operating and if the Lusca 12 watt LED is used out of the water for more than 5 minutes it will drop to a lower power setting to prevent overheating. Turning the light off and back on will reset this safety feature.

WOW>...Light Monkey has come out with their 35w HID!!!  The Ballast is built into the head instead of the can, providing more options and configurations with changing heads underwater!  Please see all of the options below with E/O Cords.  The price is for just the 35w HID Head, but you can add a canister below. 10aH=150 minutes of burn 15aH=270 mins 20aH=330 mins Whether you're swimming your favorite reef or plunging to the depths of the Nest, we have your illumination needs covered.   This light is machined from solid Delrin and is warranted to withstand depths up to 500' (150m). Because of the optimal power rating and compact size, Light Monkey batteries consist of Lithium Polymer cells. The batteries are housed in a factory-sealed canister to prevent water intrusion in case of an improperly-latched lid or forgotten o-ring. These light systems all include a universal charger that accepts an input voltage of 100V-220V with a 1.5aH output. The charger is delivered with a standard US input cord, but adapters are available for Australia, Europe, and the UK. Switch pockets are recessed into the factory-sealed dry lid for additional defense of the switch and boot. The dry lid also helps to ensure protection of the light system in the unfortunate case of a cut cord or punctured switch boot. ALL Light Monkey lights fall below the Equivalent Lithium Content (ELC) threshold mandated by TSA, and are both safe and allowed for air travel.

  Our LD-50V head only is a 50W HID killer. Hard-wired, 5000 Lumen @ 90 CRI 5600 Kelvin Set 1 High @ 46W, 5000 Lumen Set 2 @ 38W, 4000 Lumen Set 3 @ 22W, 3000 Lumen Set 4 @ 2W, 900 Lumen Set 5 Low @ 5W Variable Output – 5 settings 125 degree beam angle 1″ Ball Arm Mounting System with Light Head Clip Stack Cap Over heat protection for the LED’s, can be used on low out of the water .

This light is under the 300 watt hours that TSA requires.  You can take this as a carry on.  EX:The 20amp version puts out only 197 watt hours. This Lusca 21 Watt LED is powered by a 10 amp Li-Po rechargeable battery pack providing 5 hours of burntime. The 21 Watt LED emitter outputs 1100 lumens at 5600 kelvin on full power. The Emitter is rated at 50,000 hours and is focused to 6 degrees.New Dry Lid is completely sealed providing protection from water intrusion due to a cut cord or switch boot.Battery Canister is completely sealed preventing water intrusion due to improperly latched lid or forgotten o-ring. Dry Weight is 5 lbs.(2.3kg) 2 lbs(.9 kg) Negative. Recharge Time from Complete Discharge is 7 hours. Universal Input Charger. US Input Cord Provided, UK and European Input Cord Available. The canister is machined from Solid Rod of Delrin and the light head is black anodized aluminum. The light head is 2"(50mm) in diameter and 4"(100mm) in length. The canister 9"(22.7 cm) Length, 2.75"(7 cm) Diameter. Comes complete with goodman handle that can be used in a hard or elastic mode. LED's generate heat when operating and if the Lusca 21 watt LED is used out of the water for more than 5 minutes it will drop to a lower power setting to prevent overheating. Turning the light off and back on will reset this safety feature.   DUAL OUTPUT AVAILABLE IN 20 and 26 AMP MODELS ONLY

10 Watt HID Bulb for Monkey Light  Light.

5 - 12 LED   Twist on/off activation with double o-ring seal Powered by a 5.2aH (57.5wH) Li-Ion battery pack  300 minutes of burn time 1200 Lumen output at 5600 Kelvin Length - 7.5" (9 cm)  Diameter - 2" (5 cm)  Dry Weight - 2.38 lbs (1.08 kg) Negative in Water -  .69 lbs (.15 kg)  Recharge time from complete discharge - 3 hours UN 38.3 Test Compliant BATTERY IS SAFE FOR AIR TRANSPORT  

10 Watt Focusable HID System with 5.2AH Lithium Ion Battery Pack in Screw Cap PVC Canister (Belt or Backplate Mount),with the new rotary switch, HID10HC- Harness Clip, Protective Rubber Cover and Universal Fast Charger (100-240 VAC) and car adapter. Burn Time 4+ hours

21/13 Watt Focusable HID System with on/off/21/13 watt switch on the head, 5.2AH Lithium Ion Battery Pack in Screw Cap PVC Canister with the new rotary switch (Belt or Backplate Mount), HID-GSHR Adjustable Rigid Goodman Handle, and Universal Fast Charger (100-240 VAC) and Car adapter. Burn Time 2+ hours

An intensely bright 1000 Lumen 8 degree (Full Angle) LED assembly brighter than a 10 watt HID, depth rated to 1000', up to a 100,000+ hour lamp life. This is the toughest light you'll ever own. The 12 volt head can be turned on and off at the lighthead and can be configured to connect to your existing battery system or with a Sartek canister for burntimes from 3 hours to 24 hours. Lifetime warranty against material and workmanship defects.